1. Ease of use one button turn on
2. Automatic frequency and dwell time programmed in unit (see table)
3. Automatic shut off
4. Frequency deviation as noted in table and gating of 4 cycles per second at 50% duty cycle
5. Frequency deviation is from minus deviation to plus deviation within .125 seconds
6. Extended options include, additional 13 frequencies and can run any of the 32 frequencies individually up to 5 minutes each (fail-safe timer)
7. Special testing and calibration mode
8. Both Extended and testing modes not normal user accessable

Normal Mode

Upon application of power to the unit the red led within the STOP switch will light. Pressing the START switch will begin the sequence of frequencies for they're prescribed duration. Pressing STOP will stop the unit at any time and return to power up configuration. Upon completion of all of the frequencies in the table the unit will stop.

Extended Mode

To enter extended mode after power is applied you press and hold START and then press the STOP switch and release, you must continue to hold the START switch for 2 seconds until the STOP light goes out and the START light lights. Using the START switch press to advance the frequency number or hold until the frequency number comes up. After a delay of 5 seconds treatment will begin. Treatment lasts for up to 5 minutes or until the STOP switch is pressed.

Testing & Calibration Mode

To enter the test and calibration mode you do the same as for extended mode with the exception of holding the START switch for and additional 2 seconds. The generator will cycle through the necessary test and calibration steeps.